REDLINERS.RU

Код: Выделить всё

The manual ones can be converted. It's just that the Auto ones happen to have most of the hardware already present for a P28 conversion. No need to source hard to find parts.

I don't know where you've heard that the Auto P06 are useless but to me they are even better than the manuals :p

Here's what you need to do to convert your P06 to Manual (some ECU versions may vary tough)

1- remove RP17 and RP18 (small 1/8w resistors located at the bottom right corner)
2- replace RP18 with a jumper wire (or a 0ohm resistor)

You can then remove the drivers at IC15 and IC16 (sk5050) and use them for a P28 conversion :p You could leave them in place tough.