К слову на K24A2 точим ?
Или может проще купить дроссельную заслонку с 2006 года, вроде где-то читал что она там большего диаметра...http://tsx.acurazine.com/forums/showthr ... ge=5&pp=40
Did anyone that did this mod perform the ECM/PCM Idle Learn Procedure listed on page 11-230 of the Helm manual? I quote:
"The idle learn procedure must be done so the ECM/PCM can learn the engine idle characteristics.
Do the idle learn procedure whenever you do any of these actions:
-The ECM/PCM is replaced.
-The ECM/PCM is reset.
-The throttle body is replaced."
I can post the actual procedure if anyone wants to try it.
~~
I bought xizor's bored tb a long time ago and tried installing it when i installed the s/c, and found the same problems he did, so I swapped back the stock one.
I think i'll try out the procedure this weekend with the bored tb to see if it calms the idle down.
Here's the procedure:
"1. Make sure all electrical items are off.
2. Do the ECM/PCM RESET in the CLEAR MENU with the HDS.
3. Turn the ignition switch ON (II) and wait for 2 seconds.
4. Start the engine, and hold it at 3,000 rpm with no load (in Park or neutral) until the radiator fan comes on, or until the engine coolant temperature reaches 194 degrees F.
5. Let the engine idle for about 5 minutes with the throttle fully closed.
NOTE: If the radiator fan comes on, do not include its running time in the 5 minutes."
I wonder if step 2 is the same as just pulling the ECU fuse for a couple minutes?
